Metrohm viva 1.0 (process analysis) - Manual (Page 913)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
8 Manual control
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 901
Input range 0 - 999999
Default value 10
Selection s | min
Default value s
Status
Display of the current status.
Selection ACTIVE | INACTIVE | ERROR
[Start]
Sets the stepping motor to ACTIVE.
[Stop]
Sets the stepping motor to INACTIVE.
Reset
The motor control can be reset to factory settings on this tab.
Port description
Display of the port description.
Port
Display of the internal description of the port.
Type
Display of the port type.
Timeout
Time in seconds or minutes within which the action must have run
through completely. If this is not done after the maximum waiting time
has expired, the status of the stepping motor will be set to ERROR.
Input range 0 - 999999
Default value 10
Selection s | min
Default value s
Status
Display of the current status.
Selection ACTIVE | INACTIVE | ERROR
[Set]
Resets the stepping motor to factory settings.