Metrohm viva 1.0 (process analysis) - Manual (Page 322)

4.6 Curves subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
310 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Selection on
The marking of the curves selected in the table is activated with this but-
ton.
Selection off
The marking of the curves selected in the table is deactivated with this
button.
4.6.1.3 Curve display MEAS
Tabs
In the curve window a tab with the corresponding command name and
the run index (e.g. Chloride.1) is provided for each run of a measuring
command; their sequence is determined by the method.
Curve display for MEAS commands
The following elements are displayed in the upper part of the curve win-
dow:
￭ Axes with labeling (measured quantity and unit)
￭ Measurement curves
Zoom
Curves can be zoomed within the curve display as often as required by
spanning a square with the left mouse button pressed down. Zooming
can be undone by double-clicking or using the context-sensitive Show all
menu command.
NOTE
When a new determination is selected the complete curve is always
shown, i.e., the zoom range is not retained when the determination is
changed.
Context-sensitive menu items
Show all Resets the zoom and shows curves completely.
Measuring point
list...
Opens the Measuring point list - 'Command name.#' dialog window.
Properties Curves
#… Opens the Properties - Curves # dialog window for the definition of the prop-
erties of the curve display (see Chapter 4.5.2.5.5.2.4.3, page 286).
Copy graphics Copies curves to the clipboard.