Metrohm viva 1.0 (process analysis) - Manual (Page 541)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 529
Timeout
on | off (Default value: off)
If this check box is activated, then a maximum waiting time can be
entered for the input signal.
Input range 0.0 - 9,999.9
Default value 10.0
Selection min | s
Default value min
NOTE
If the Timeout check box is not activated, then there will be an infin-
itely long wait for the input signal.
5.5.2.9.4 SEND
5.5.2.9.4.1 SEND - Overview
Dialog window: Method ▶ SEND ▶ Properties... ▶ SEND - 'Command name'
Command for sending event messages to commands, tracks or to
viva.
Appearance
The command has the following appearance:
Parameters
The parameters for the SEND command are configured in the following
dialog window:
￭ SEND - Properties
Command variables
The following command variables are generated by the SEND command
in the method run and can be used in formulas under the designation
'Command name.Variable identification':
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started