Metrohm viva 1.0 (process analysis) - Manual (Page 864)

7.11 Stepping Motor Controller
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
852 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Selection Record message | Display message | Cancel
determination
Default value Display message
Record message
The message that the validity period has expired will be automatically
saved with the determination.
Display message
A message is displayed and you can select whether you want to con-
tinue the run or cancel it. If the run is continued then the message that
the validity period has expired will be automatically saved with the
determination.
Cancel determination
The determination is not started. The following message must be con-
firmed with [OK].
7.11 Stepping Motor Controller
7.11.1 Stepping Motor Controller - Overview
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Properties ▶ Properties - 'De-
vice type' - 'Device name'
The properties of a Stepping Motor Controller are set on the following
tabs:
￭ (see Chapter 7.10.2, page 818)
General device information such as device name, device type, serial
number, etc.
￭ (see Chapter 7.10.3, page 819)
General settings for the IO controller.
￭ (see Chapter 7.10.4, page 819)
Digital inputs of the IO controller.
￭ (see Chapter 7.10.5, page 824)
Digital outputs of the IO controller.
￭ (see Chapter 7.11.6, page 861)
Stepping motors of the IO controller.
￭ (see Chapter 6.5.3.3, page 693)
Information on GLP tests and GLP monitoring.
7.11.2 Properties - General
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ General
Device name
Designation of the device, can be freely defined by the user.