Metrohm viva 1.0 (process analysis) - Manual (Page 332)

4.6 Curves subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
320 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Line thickness
Line thickness of the measurement curve for sample solutions.
Input range 1 - 10 pixels
Default value 1 pixels
Spiking/standard
Color of the measurement curve for spiking solutions and standards.
Selection black | 13 colors
Default value black
Line thickness
Line thickness of the measurement curve for spiking solutions and stand-
ards.
Input range 1 - 10 pixels
Default value 1 pixels
Other
Color of the measurement curve for non-defined solutions.
Selection orange | 13 colors
Default value orange
Line thickness
Line thickness of the measurement curve for non-defined solutions.
Input range 1 - 10 pixels
Default value 1 pixels
Base line
on | off (Default value: on)
If this check box is activated, then the baseline and base points are shown
(only for smoothed curves) and the color of the baseline can be selected.
This parameter can be edited only for Quantity = Current [A].
Selection red | 13 colors
Default value red
Line thickness
Line thickness of baselines.
Input range 1 - 10 pixels
Default value 1 pixels