Metrohm viva 1.0 (process analysis) - Manual (Page 175)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Workplace
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 163
3.9.2.2 Curve properties CVS
3.9.2.2.1 Curve properties CVS - x axis
Tab: Workplace / Database ▶ Curves # ▶ Properties Curves # ▶ x Axis
Parameters for the graphical display of the curves on the x axis.
Quantity
Selection of the quantity to be shown on the x axis.
Selection Current [A] | Voltage [V] | Time [s] | Current
measuring range [A]
Default value Voltage [V]
Label
Freely definable axis label for the x axis. If auto is selected, then the desig-
nation from the Quantity field will be used.
Selection 50 characters | auto
Default value auto
Numerical format
Selection of the numerical format for the labeling of the x axis.
Only for CVS
Selection decimal | scientific | engineering
Default value engineering
decimal
The axis is labeled in the decimal format ±##.### (floating-point num-
ber).
scientific
The axis is labeled in the scientific format ±#.###e±###.
engineering
The axis is labeled in the technical format ±###.###+prefix (engi-
neering format). The prefix (m, µ, n, p) is added to the figure.
Manual scaling
on | off (Default value: off)
If this check box is activated, then the x axis can be manually scaled in the
curve window. In this case, the Start value and End value fields can be
edited. If this check box is not activated, then the x axis will be automati-
cally scaled.
Start value
Initial value for scaling the x axis.