Metrohm viva 1.0 (process analysis) - Manual (Page 453)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 441
Input range 0.0 - 1.0
Default value 0.3
Slope
Minimum difference between the slope before and after the break point.
The smaller the difference, the more break points will be found.
Input range 0.0 - 10.0
Default value 0.9
Smoothing factor
The higher the smoothing factor, the fewer endpoints will be found.
Input range 2 - 20
Default value 5
Window
A range (window) can be defined on the measured value axis or on the
time axis. The break point evaluation will only be carried out in the
defined window. Only the first break point in the defined window will be
recognized.
Selection Measured value | Time | off
Default value off
Lower limit
Measured value for the lower limit of the window.
Time for the lower limit of the window.
Window = Measured value
Input range
0 - 4,000 mAU
Default value 0 mAU
Window = Time
Input range
0 - 999,999 s
Default value 0 s
Upper limit
Measured value for the upper limit of the window.
Time for the upper limit of the window.
Window = Measured value
Input range
0 - 4,000 mAU
Default value 4,000 mAU