Metrohm viva 1.0 (process analysis) - Manual (Page 301)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Database
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 289
Label
Freely definable axis label for the y1 axis. If auto is selected, then the des-
ignation from the Quantity field will be used.
Selection 50 characters | auto
Default value auto
Manual scaling
Start value
Initial value for scaling the y1 axis.
Editable only when autoscaling is deactivated.
Input range
-1.00E+12 - +1.00E+12
Default value -1.00E+12
End value
End value for scaling the y1 axis.
Editable only when autoscaling is deactivated.
Input range
-1.00E+12 - +1.00E+12
Default value +1.00E+12
Curve
Curve color
Selection of the color for the line of the curve.
Selection 13 colors | light blue
Default value light blue
Symbol
Selection of the symbol for the display of the individual measuring points.
Selection ● | ╳ | ✸ | ￭ | ▲ | no symbol
Default value no symbol
no symbol
Measuring points are not shown.
NOTE
The individual measuring points are no longer displayed for curves for
which the distance between two measuring points is smaller than 5 pix-
els, even if a symbol has been selected. In this case, the graphics win-
dow might be enlarged in order to display the symbols again.