Metrohm viva 1.0 (process analysis) - Manual (Page 577)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 565
Set default
Writes the content of the Default value field from the configuration
on the analog output.
Value
Mapped value that is to be written on the analog output. A fixed value or
a formula (formula editor, CTRL F or right mouse button) can be entered.
Mapping area and unit of the value are defined in the configuration of the
analog output.
If the value that is to be written is smaller than the 0% Mapping, then
the smallest possible value (Low level (0 %)) is output; in the case of val-
ues greater than the 100% Mapping, the greatest possible value (High
level (100 %)) is output.
5.5.2.11.5 ANALOG IN
5.5.2.11.5.1 ANALOG IN - Overview
Dialog window: Method ▶ ANALOG IN ▶ Properties... ▶ ANALOG IN - 'Command
name'
Instruments
This command can be executed with the IO controller.
Appearance
The command has the following appearance:
Mode of operation
At the time of the command, the statuses of all of the analog inputs are
entered and saved in command variables.
Parameters
The parameters for the ANALOG IN command are set on the following
tabs:
￭ General
Parameters for instrument.
￭ Stop criteria
Parameters for the definition of the stop criteria.
Command variables
The following command variables are generated by the ANALOG IN
command in the method run and can be used in formulas under the des-
ignation 'Command name.Port name.Variable identification':