Metrohm viva 1.0 (process analysis) - Manual (Page 286)

4.5 Determination overview
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
274 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Calibration data
Calibration factor
Concentration of the standard in the measuring vessel for the evaluation
ratio (only for DT).
Date calibration
Date on which the calibration was carried out.
Determination ID calibration
Determination ID of calibration.
Table of measurement curves
A list of the measurement curves recorded is shown in the table below the
voltammograms or calibration curve. It contains the following columns:
CALL
Name of the CALL command that has called the corresponding VA track.
Var
Variation number.
Rep
Replication number.
Peak voltage
Peak potential determined.
Area
Peak area determined (for Evaluation quantity = Area).
Height
Peak height determined (for Evaluation quantity = Height).
Used
on | off (Default value: on)
Shows whether a calibration point is to be used for the calculation of the
calibration curve or not.
Context-sensitive menu items for table
The table cannot be edited directly but only via the following context-sen-
sitive menu items: