Metrohm viva 1.0 (process analysis) - Manual (Page 843)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
viva 1.0 (for Process analysis)
￭￭￭￭￭￭￭￭ 831
Entry 50 characters
Default value AnOut_x_y_z
The following characters must not be part of the
port designation: \, ', ., {, }, [, ].
Port specification
Shows the port specification.
Type
Shows the port type.
Low level (0 %)
Shows the lowest analog output value.
This value is read out automatically and depends on the Type.
High level (100 %)
Shows the highest analog output value.
This value is read out automatically and depends on the Type.
Unit
Shows the unit of the analog output value.
This value is read out automatically and depends on the Type.
NOTE
With the aid of the following parameters the physical values that are
applied to the analog output can be mapped to any measured value.
The transfer function is linear.
0% Mapping
Input range -214,783,648.000 - 214,783,647.000
Default value 0
100% Mapping
Input range -214,783,648.000 - 214,783,647.000
Default value 100
Unit
Unit of the measured value to be used.
Entry 50 characters
Default value %