Metrohm viva 1.0 (process analysis) - Manual (Page 602)

5.6 Evaluation subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
590 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Table
The type of calibration curve is defined in the table of calibration curves
for each substance. The table cannot be edited directly and contains the
following columns:
Calibration method MLAT
Substance
Name of the substance. Substances can neither be added nor deleted
here, this must take place in the substance table (see Chapter 5.6.3, page
579).
Evaluation quantity
Measured quantity for the evaluation of the calibration curve.
Weighting
Information as to how the points of the calibration curve are to be weigh-
ted.
Curve type
Curve type for the evaluation of the calibration curve.
Calibration method DT
Substance
Name of the substance. Substances can neither be added nor deleted
here, this must take place in the substance table (see Chapter 5.6.3, page
579).
Evaluation quantity
Measured quantity for the evaluation of the calibration curve.
Weighting
Information as to how the points of the calibration curve are to be weigh-
ted.
Evaluation ratio
Evaluation ratio Q/Q(0) with which the calibration factor is calculated.
Curve type for standard
Curve type for the evaluation of the calibration curve.
Begin of evaluation standard
Evaluation ratio Q/Q(0) with which the calculation of the regression for
the standards is to be started.