Metrohm viva 1.0 (process analysis) - Manual (Page 888)

8.4 Manual control - Functions
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
876 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Stirring time
Entry of the time during which the stirrer has to remain switched on. If
this parameter is modified after stirring has started, it is not valid until the
next stirring procedure.
Input range 1 - 999,999 s
Default value 60 s
[Start]
Starts stirring for the selected stirrer. The remaining time is shown in the
status display. The stirrer will be switched off automatically after the stir-
ring time has elapsed.
[Stop]
Stops stirring for the selected stirrer.
8.4.4 Remote functions
Program part: Manual control
If a Remote Box or a remote interface is selected in the subwindow for the
device selection, then the functions and parameters that are possible with
the elements appear in the subwindow for functions/parameters.
Devices
The remote functions can be carried out with the following devices:
Voltammetry instrument: 894
Sample changer: 814, 815, 858, 919
Spectrometer: Avantes
Dosing Interface: 846
Input signal
Is not shown for the Avantes spectrometer because it has no input lines.
Current status
Shows the current status of the eight input lines.
Templates/Entry
If the current status corresponds to one of the defined templates for the
inputs, the corresponding name is shown here.
NOTE
Only templates without asterisks * are recognized.