Fagor America CNC8070 - Manual (Page 103)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
MANUAL (
J
OG)
MODE
O
per
at
io
n
s
wi
th
t
he
axe
s
4.
(S OFT V03.0 X )
69
Continuous JOG
In continuous jog, the axes keep moving while the jog keyboard is acted upon.
Continuous jog allows moving several axes at the same time.
Proceed as follows:
Incremental JOG
In incremental jog, the axis moves a specific distance every time the key is pressed.
In incremental jog, the axes may be jogged simultaneously.
Proceed as follows:
1. Turn the jog selector switch of the operator panel to one of the incremental jog
positions. Each position will move the axis a fixed distance; the typical values are
the following.
2. Jog the desired axis using the JOG panel (keypad). Every time the JOG panel
is acted upon, the axis will move the distance indicated on the dial of the jog
selector switch.
If while moving, a second axis is selected, the new one will move at the same time
and under the same conditions.
1. Turn the jog selector switch
(a)
of the operator panel to the continuous jog position
on the dial.
2. Jog the desired axis using the JOG panel (keypad). The axis will move while acting
upon the JOG panel.
If while moving, a second axis is selected, the new one will move at the same time
and under the same conditions.
(a)
If while the axes are moving, the rapid key is pressed, the axes will move at the rapid
rate set by the machine manufacturer. This feedrate will be applied while that key is
kept pressed and, when released, the axes will recover their previous feedrate. This
rapid rate may be varied between 0% and 200% with the feedrate override switch on
the operator panel.
Selector position Distance
1 0.001 mm or 0.0001 inches
10 0.010 mm or 0.0010 inches.
100 0.100 mm or 0.0100 inches.
1000 1.000 mm or 0.1000 inches.
10000 10.000 mm or 1.0000 inches.