Fagor America CNC8070 - Manual (Page 306)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
13.
SETUP ASSI
STANCE
O
s
c
illo
s
c
o
p
e
(S OFT V03.0 X )
272
Softkey menu
Horizontal softkey menu
The horizontal softkey menu offers the following options:
‡ Softkey
CONFIG
It access the configuration screen. It may be used to define which variables will
be displayed, their scale, colors, time base, the Trigger, the trigger condition, the
parameters to act upon, etc.
‡ Softkey
DATA
It accesses the data processing submenu. This submenu serves to save and load
the captured trace as well as the configuration defined for it.
It may also be used to send data of the captured trace out to printer or to a file.
‡ Softkey
OVERLAP CHANNELS
Wit this option, several channels may be overlapped.
When this option is selected, the softkey color changes to red.
‡ Softkey
AUTOSCALE
When autoscaling a channel, the system determines the proper vertical scale and
offset so the signal appears as enlarged as possible inside its graphic area.
‡ Enlarge screen
With this option, it is possible to enlarge the graphics window to the left, using the
area that shows the variables to be displayed. Pressing the same softkey returns
the screen to the previous size.
‡ Softkey
FREEZE SCREEN
The display is "frozen" without interrupting the data capture. When this option is
selected, the softkey shows "Resume".
This softkey only appears on the horizontal softkey menu if the capture is in
continuous mode. To set the capture in continuous mode, change the "mode"
option of the configuration screen.
‡ Softkey
BEGIN CAPTURE
Start taking data to show it graphically.
When this option is selected, the softkey shows "Stop".
i