3 configure the graphic environment, Configure the graphic environment, Cnc 8070 – Fagor America CNC8070 User Manual
Page 324
Operating manual
CNC 8070
13.
SETUP ASSI
STANCE
The
ci
rc
ul
ar
it
y (
roundne
ss)
t
e
st
(S
OFT
V03.0
X
)
290
13.3.3 Configure the graphic environment
This operation may be carried out before or during the test. If they are modified during
the test, the screen is cleared and the graphic representation goes on.
The following graphic characteristics may be defined from the data window.
• Number of divisions on both sides of the theoretical circle.
• Scale or value in microns of each division.
• Error margin. Percentage of the area that is occupied by the error margin
(divisions area).
Initialize the data
When accessing the circularity test, it assumes the values used last. Pressing the
INITIALIZE
softkey restores the default values.
Number of divisions
5
Scale:
10 microns/division
Error margin:
50 %
Bear in mind that the softkey
INITIALIZE
initializes all the data of the
window, including the values of the machine parameters.
i