Fagor America CNC8070 - Manual (Page 294)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
12.
MACHI
NE PARAMETERS
Par
a
m
e
te
r t
a
b
le des
cr
ip
ti
on
(S OFT V03.0 X )
260
12.2 Parameter table description
The machine parameter tables have the following structure:
A. Name of the selected machine parameter table.
B. Parameter list.
C. Parameter value, set by the user.
D. Units used to define the parameter.
E. Limit values for the parameter.
F. Default value of the parameter.
G. Parameter description.
The section on "12.3.1 Data editing and validation" in this chapter shows how to
edit the parameters of the tables.
Certain parameters cannot be edited; they only access a set of parameters or a data
table. These parameters will be identified as follows.
To access the data associated with the parameter, select the parameter with the
cursor and press [ENTER]. To return to the previous parameter table, press [ESC].
To access a group of parameters.
To access a data table.
A
B C D E F
G
To obtain further information about the data appearing in the table, refer to the
chapter on machine parameters of the Installation and Start-up Manual. i