Fagor America CNC8070 - Manual (Page 257)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operation manual
8070 CNC
PLC
"P
rogr
am
s"
ser
v
ic
e
11.
(S OFT V03.0 X )
223
11.2.2 Files of the PLC project PLC (Softkey)
When selecting a program of the PLC project at the service window, the softkey menu
will offers the following options.
Files of the PLC project "Edit"
It is used to edit the selected PLC file.
Selecting this option access the editing window (section on "11.3 Program editing"
in this chapter).
Files of the PLC project "Monitoring"
It is used to monitor the selected PLC file.
Selecting this option access the monitoring window (section on "11.5 Program
monitoring" in this chapter).
Files of the PLC project "Eliminate"
It deletes the selected file of the PLC project (the file will still be available in the CNC's
hard disk).
Files of the PLC project "Rename"
It is used to change the name of the selected file.
Files of the PLC project "Copy"
It is used to make a copy of the selected file.
When selecting this option, the CNC shows a list with the programs stored at the CNC.
To make a copy of the file:
1. Select the destination folder for the copy.
2. Define the file name at the bottom window. To replace an existing file, select it from
the list.
3. Press [ENTER] to copy the file or [ESC] to cancel the selection and close the file
listing.
Keys for selecting a service
To switch windows.
To close and open a folder submenu.
To move the cursor thru the elements of the window.
To save the new program.
To cancel the selection and close the programs listing.