Fagor America CNC8070 - Manual (Page 307)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
SETUP ASSI
STANCE
O
s
c
illo
s
c
o
p
e
13.
(S OFT V03.0 X )
273
Vertical softkey menu
Depending on which data has the focus, the vertical softkeys show different options .
Focus on a variable of a channel
When the focus is on any of the variables, the vertical softkeys will be:
Focus on the "WIN" field
With win, it shows the oscilloscope window where it is. When the focus is on this field,
the vertical softkeys will be:
Focus on the "T/Div" field
When the focus is on the "T/Div" field, the following softkeys will appear.
The scale of the graphic may be changed with the "scale" softkeys. The new scale
value will appear on the graphic next to the corresponding variable.
The graphics of the desired channel may be moved up and down using the offset
softkeys.
This softkey may also be used to center the graphics.
When the focus is on any of the variables, a new variable name may be either
keyed in or selected without having to go to "CONFIG". i
It takes the window to the beginning.
It takes the window to the end.
It takes the window to the trigger. If there is no trigger, it will go to the center of the
window.
Moves the window to the left.
Moves the window to the right.
Using the autoscale softkey, the oscilloscope selects the right time scale so the signal
appears as large as possible inside its corresponding graphic area.
It increases or decreases the time scale.