Fagor America CNC8070 - Manual (Page 313)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
SETUP ASSI
STANCE
O
s
c
illo
s
c
o
p
e
13.
(S OFT V03.0 X )
279
Saving, loading and resetting the condigurations
When defining a new configuration of variables to be displayed and parameters
modified at the oscilloscope, the system allows saving that configuration into a file.
Likewise, the system allows loading a configuration that was saved previously or
resetting the current configuration.
Save
To save the current configuration, go to the configuration screen and press the "Save"
softkey.
After this, a new screen appears showing the available configurations with the focus
on the last one.
Also, it is possible to rename the new configuration whose extension must be "osc".
Load
To load a previously saved configuration, go to the configuration screen and press
the "Load" softkey.
Then, a new screen appears showing a list of previously saved configurations, being
possible to select any of them.
Reset
Pressing the "Reset" softkey of the configuration screen deletes or initializes the
current configuration. There are neither variables nor parameters selected and the
rest of conditions (colors, trigger, etc.) assume the values assigned by default.