Fagor America CNC8070 - Manual (Page 131)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
EDI
T
IN
G-
SI
MULATI
ON MODE
Edi
ti
ng wi
n
dow
6.
(S OFT V03.0 X )
97
6.2 Editing window
It may be used to edit, modify or see the contents of a part-program and check the
program for syntax errors.
Description of the editing window
The editing window shows the following information:
A. Title bar
Name of the program selected for editing. It also indicates whether it is a read-
only program or not (if read-only, while simulating or executing).
An "*" next to the program means that the program has been modified since last
saved (only if automatic program saving is off).
B. Edit area.
Program editing area showing its contents.
C. Editing errors (if any).
List of errors occurred while editing the program or syntax errors found in the
syntax check.
D. Status bar.
Information about cursor position and the status of the editor options such as:
AUTONUM: Automatic block numbering. When active, the CNC automatically
numbers the new blocks being generated.
CAP: Capital letters. When active, the text is always written in capital
letters.
OVR: Overwrite text. It toggles between overwriting and inserting text.
When active, it overwrites the existing text.
NUM: Numeric keypad active.
B
C
D
A