Fagor America CNC8070 - Manual (Page 92)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
3.
AUTOMATI
C
MODE
Pr
ogr
am
s
e
le
ct
ion
and
ex
ecut
io
n
(S OFT V03.0 X )
58
3.6.2 Program execution
The name of the program selected in the channel for execution appears on the
general status bar. See
"3.1.2 Description of the general status bar" on page 36.
If not indicated otherwise, the program execution will begin from the first block of the
program to the execution of one of the end-of-program functions "M02" or "M30". As
an option, it is possible to define the first and last blocks of the execution. See
"3.3 Data screen (softkeys)" on page 41.
Start executing
To start the execution of the program, press [START] on the Operator Panel.
The program may be executed in –single block– or –automatic– mode; the mode may
be selected even while executing the program. When –single block– is active, the
screen will display the relevant symbol on the general status bar.
If the –single block– mode is active, program execution will be interrupted at the end
of each block; the [START] key must be pressed again to execute the next block. If
the –automatic– mode is active, the program will be executed all the way to the end
or up to the block selected as end of execution.
Interrupting the execution
The [STOP] key interrupts the execution of the program. Press [START] again to
resume execution from where it was interrupted.
The execution may be interrupted at any time, except when threading. In that case,
it will be interrupted at the end of the threading operation.
Stop the execution
The [RESET] key cancels the execution of the program and resets the CNC to its initial
conditions.
The program selected for execution may be executed in any operating mode
by pressing [START] on the Operator Panel. Th e CNC will request
confirmation before starting to execute the program. i