Fagor America CNC8070 - Manual (Page 206)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
9.
TOOL
AND MAGA
Z
INE TABLE
Showi
ng t
abl
es and com
m
on oper
at
io
n
s
(S OFT V03.0 X )
172
9.1 Showing tables and common operations
9.1.1 Table selection
This operating mode consists of several tables. The various tables may be selected
using the horizontal softkeys.
When selecting one of these tables, it is displayed on the screen and the vertical icon
menu shows the icons associated with that table. Later sections of this chapter show
a more detailed description of the icons and operations that may be carried out in each
table.
Simultaneous operations for all the tables
If no table is currently selected, the vertical softkey menu will show the following
softkeys to save or load all the tables. See
"9.1.3 Save and load the tables" on page
174.
Softkey Table
Tool table.
This table defines the tools available and the data associated
with each one of them. This table is common to all the
magazines.
Active-tools table.
This table shows the tool that is active in each channel and the
data associated with it.
Change process.
This table monitors the tool changes being executed in each
channel.
Tool magazine table (there is one table per magazine)
For each magazine, it shows the tool distribution and the
remaining life time of each tool (if tool life monitoring is active).
If the magazine has a changer arm, it shows the tool located
in it.
The description of the magazine type can also be shown.
The icon associated with this table depends on the software
configuration (lathe or mill).
Pressing the key for the previous menu deselects the active table. When no table has
been selected, the vertical icon menu may be used to save and restore all the tables.
Save the tables
Saves the data of all the tables.
Recall the tables
It restores the data previously saved for all the tables.