Fagor America CNC8070 - Manual (Page 19)

CNC 8070
Ver
s
io
n
hi
st
or
y
(S OFT V03.0 X )
VII
Software V2.03 April 2005
Electronic-cam editor. INST
Optimize the reading and writing of variables from the PLC. Only the following will be
asynchronous.
• The tool variables will be read asynchronously when the tool is neither the active one
nor in the magazine.
• The tool variables will be written asynchronously whether the tool is the active one or
not.
• The variables referred to local arithmetic parameters of the active levels will be read
and written asynchronously.
INST / PRG
Spindle parking and unparking. INST
The RESETIN mark is not necessary to park/unpark axes or spindles from the PLC. INST
Sercos control in velocity. INST
Behavior of the beginning and end of tool radius compensation when not programming
a movement. PRG
Changing the type of radius compensation while machining. PRG
Via program, loading a tool in a specific magazine position. PRG
Programming of modal subroutines (#MCALL). PRG
Executing a block in a channel (#EXBLK). PRG
Programming the number of repetitions in the block (NR). PRG
Direct resolution of 2D and 3D pockets without requiring a softkey. PRG
Simulating a canned cycle of the editor separately. PRG
New method to jog the axes using the JOG keyboard. Axis keys and independent
directions. INST / OPT
Importing DXF files from the program editor or from the profile editor. OPT
Importing programs of the 8055/8055i CNC from the program editor. OPT
Use a softkey to select the repositioning of the spindle after tool inspection. OPT
Backup-restore utility. OPT
Improved profile editor. OPT
Assistance in the program editor. Contextual programming assistance.
• When programming "#", it shows the list of instructions.
• When programming "$", it shows the list of instructions.
• When programming "V.", it shows the list of variables.
OPT
Specific password for the machine parameters for kinematics. OPT
Save the CAN configuration for testing it when starting up the system. OPT
The diagnosis mode shows detailed information on the Sercos connection (Type and
version of the drive and motor connected to it). OPT
It is possible to print all the information on the configuration from any section of the
diagnosis mode. OPT
It is possible to simulate a cycle separately from the cycle editor. OPT
Setup assistance.
• Oscilloscope.
• Bode diagram.
• Circularity (roundness) test.
OPT
Feature
Feature
New values of machine parameter SERPOWSE for the "Sercos II" board. INST
Independent-axis programming commands. INST
Electronic-cams programming commands. INST
New signals that may be consulted and changed for the independent interpolator
(electronic cam and independent axis) INST
The simulated axes are ignored regarding the validation code.
When unifying parameters, G00FEED and MAXVOLT are not sent out to the drive.
INST
Electronic-cam programming instructions (#CAM ON / #CAM OFF). PRG
Independent-axis programming instructions (#MOVE ABS / #MOVE ADD / #MOVE INF
/ #FOLLOW ON / #FOLLOW OFF). PRG
G112. Change the drive's parameter set. PRG
DDSSETUP mode OPT
G31. Temporary polar origin shift to the center of interpolation. PRG