Fagor America CNC8070 - Manual (Page 163)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
EDI
T
IN
G-
SI
MULATI
ON MODE
P
rogr
am
wi
ndo
w (
s
of
tk
eys)
6.
(S OFT V03.0 X )
129
6.7.2 Stop condition
If no last block is established, the simulation of the program will end after executing
one of the end-of-program functions "M02" or "M30".
Subroutine selection
To select the stop condition in a global subroutine which has been called upon from
the program. When selecting this option, the CNC shows a list of programs available
for selecting the desired subroutine.
To select a subroutine from the list.
1. Select from the list the program containing the subroutine or write its name in the
bottom window.
2. Press [ENTER] to open the program or [ESC] to cancel the selection and close
the program listing.
The program window will show the contents of the selected subroutine.
Last block
It sets the cursor position as the block where simulation is interrupted. If no last block
is established, the simulation of the program will end after executing one of the end-
of-program functions "M02" or "M30".
The last block may be selected using the cursor or the "Find text" or "Go to line" options
of the softkey menu.
The established last block remains active until it is canceled (with [ESC]) or a program
is simulated; in that case, the execution of one of the functions "M02" or "M30" is set
as the stop condition.
It is used to establish, in the program or in a subroutine, the block where the program
simulation will be interrupted. After executing that block, the simulation may be
resumed with the [START] icon or canceled with the [RESET] icon.
START RESET
When selecting this option, the softkey menu of the CNC shows the options available
for selecting the stop condition. To return to the main menu, press the key for the
previous menu.
Keys for selecting a program
To move the cursor thru the elements of the window.
To open the selected subroutine.
To cancel the selection and close the program listing.
Keys to move the cursor
Moves the cursor line by line.
To move the cursor page by page.
Moves the cursor to the first block or to the end of the program.