Fagor America CNC8070 - Manual (Page 223)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
TOOL
AND MAGA
Z
INE TABLE
O
per
at
ions
wi
th
t
he
to
ol
t
abl
e
9.
(S OFT V03.0 X )
189
9.3 Operations with the tool table
9.3.1 Editing the tool table
Initialize table
The table can only be initialized when the CNC is "READY". The table is initialized
from the vertical softkey menu.
Adding/removing a tool to/from the list
A tool may be added or deleted only when it is selected on the tool list. Both operations
are carried out from the vertical softkey menu.
Data editing
Proceed as follows to fill out the tool table data:
1. Select the tool to be set from the list and press [ENTER] to access its data.
2. Configure the table to show only the data that may be defined hiding the rest.
3. Define the tool data. Every time a new value is defined, press [ENTER] to validate
it.
4. Make a safety backup copy of the tool data out to a file.
When resetting the table, all the tools are deleted from the list, including
those in the spindle and on the tool changer arm. It also initializes the
active-tools table and the magazine tables because the available tools
have been erased.
Add a tool to the list.
It adds a new tool to the list. The tool is added to the list at the first free
position.
Remove a tool from the list.
It removes a tool from the list. A tool cannot be removed if it is in the
magazine, in the spindle or on the tool changer arm.
Keys for tool table editing
To move the cursor through the table data.
To validate the new value.
To activate/deactivate the selection boxes and open/close drop
lists.
To move the cursor whitin a data.
To select the line before or after the comment.
To move the cursor to the beginning or end of the comment line.