Fagor America CNC8070 - Manual (Page 296)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
12.
MACHI
NE PARAMETERS
Par
a
m
e
te
r t
a
b
le des
cr
ip
ti
on
(S OFT V03.0 X )
262
12.2.2 Compensation table
There are two types of compensation table:
• Leadscrew error compensation, which is accessed with the axis machine
parameter "COMPENSATION".
• Cross compensation, which is accessed with the general machine parameter
"CROSS COMP".
These compensation tables have the following structure:
A. Name of the selected machine parameter table.
B. Compensation point.
C. User defined axis position.
D. Amount of error to compensate in the positive direction.
E. Amount of error to compensate in the negative direction.
F. Parameter description.
The section on "12.3.1 Data editing and validation" in this chapter shows how to
edit the parameters of the tables.
A
B C D E
F
To obtain further information about the data appearing in the table, refer to the
chapter on machine parameters of the Installation and Start-up Manual. i