Fagor America CNC8070 - Manual (Page 189)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
MDI
MODE
St
anda
rd
M
D
I wi
n
dow
7.
(S OFT V03.0 X )
155
7.2.1 Block editing and execution
In this window, it is possible to edit and execute new blocks or the ones saved in the
block history. Only the blocks previously executed will be saved in the block history.
While editing, it analyzes the syntax of the block being edited. When trying to execute,
if the block is incorrect, it shows a warning message and it does not execute it.
Block editing
The blocks may be edited directly on the edit line or may be recalled from the block
history.
The recalled blocks may be modified before executing them as if they were new ones.
Block execution
The block on the edit line is executed by pressing [START] at the operator panel. Once
the block has been executed is saved in the block history.
The [STOP] key interrupts the execution of the block. Press [START] again to resume
execution from where it was interrupted.
The [RESET] key cancels the execution of the block and resets the CNC to its initial
conditions.
Keys for selecting a block from history
To access the history and select a block.
To accept the selection and show the block on the edit line.
To cancel the selection and quit the MDI mode.