Fagor America CNC8070 - Manual (Page 23)

CNC 8070
(S OFT V03.0 X )
XI
SAFETY CONDITIONS
Read the following safety measures in order to prevent harming people or damage to this product
and those products connected to it.
This unit may only be repaired by authorized personnel at Fagor Automation.
Fagor Automation shall not be held responsible of any physical damage or defective unit
resulting from not complying with these basic safety regulations.
PRECAUTIONS AGAINST PERSONAL DAMAGE
‡ Interconnection of modules.
Use the connection cables provided with the unit.
‡ Use proper cables.
To prevent risks, use the proper cables for mains, Sercos and Bus Can
recomended for this unit.
‡ Avoid electrical overloads.
In order to avoid electrical discharges and fire hazards, do not apply electrical
voltage outside the range selected on the rear panel of the Central Unit.
‡ Ground connection.
In order to avoid electrical discharges, connect the ground terminals of all the
modules to the main ground terminal. Before connecting the inputs and outputs
of this unit, make sure that all the grounding connections are properly made.
‡ Make sure that it is connected to ground.
In order to avoid electrical shock, before turning the unit on verify that the ground
connection is properly made.
‡ Do not work in humid environments.
In order to avoid electrical discharges, always work under 90% of relative
humidity (non-condensing) and 45ºC (113ºF).
‡ Do not work in explosive environments.
In order to avoid risks or damages, do no work in explosive environments.
PRECAUTIONS AGAINST PRODUCT DAMAGE
‡ Working environment.
This unit is ready to be used in Industrial Environments complying with the
directives and regulations effective in the European Community.
Fagor Automation shall not be held responsible for any damage suffered or
caused when installed in other environments (residential or homes).
‡ Install the unit in the right place.