Fagor America CNC8070 - Manual (Page 200)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
8.
USER TABLES
Fi
xt
ur
e
t
abl
e
(S OFT V03.0 X )
166
8.3 Fixture table
This table stores the clamp offsets for each axis. There are up to 10 clamp offsets.
Although the table is common to all the channels, when accessing from a channel,
it only shows the axes of that channel. The offsets of other channels may be accessed
from the vertical softkey menu.
A. Machine axes and display units (millimeters, inches or degrees).
B. Clamp offset.
C. Clamp offset value in each axes of the channel.
The end of this chapter describes how to edit this table.
Fixture offset
Besides setting the values directly in the table, they may also be set from the PLC
or via part-program using high-level variables.
The clamp offsets are used to set the position of the clamping system of the machine.
When applying a clamp offset, the CNC assumes as new clamp zero the point set
by the selected offset referred to machine reference zero (home).
To apply a clamp offset it must be activated from the program using the relevant
variable.
A
B
C