Fagor America CNC8070 - Manual (Page 311)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
SETUP ASSI
STANCE
O
s
c
illo
s
c
o
p
e
13.
(S OFT V03.0 X )
277
13.1.4 Machine parameter editing
Here is a list of machine parameters and variables of the drive that may be modified
from the oscilloscope.
The new values are assumed by the CNC after pressing [ENTER] and they are
maintained until the unit is turned off. Once the setup is completed, the changes must
be saved so they can be effective next time the CNC is turned on.
Axis or spindle machine parameters that may be edited
The table indicates the parameters that will be assumed at the beginning of the next
block. For this to be so, the instruction "#SYNC POS" must be programmed after each
motion block.
If the machine parameters are protected, when accessing any of them, the CNC will
display a window requesting a password.
Use the VALIDATE softkey to save the data. The CNC saves the new values in the
CNC tables and/or in the drive tables accordingly.
CNC Drive Associated variable Update
PRELOAD MPG.PRELOAD[tandem] Immediate
PRELFITI MPG.PRELFITI[tandem] Immediate
TPROGAIN MPG.TPROGAIN[tandem] Immediate
TINTIME MPG.TINTIME[tandem] Immediate
TCOMPLIM MPG.TCOMPLIM[tandem] Immediate
INPOSW MPA.INPOSW.[set].axis Immediate
BACKLASH PP58 MPA.BACKLASH.[set].axis Immediate
G00FEED MPA.G00FEED.[set].axis Beginning of next block
MAXVOLT MPA.MAXVOLT.[set].axis Immediate
PROGAIN PP104 MPA.PROGAIN.[set].axis Immediate
FFGAIN PP216 MPA.FFGAIN.[set].axis Immediate
MANFFGAIN PP216 MPA.MANFFGAIN.[set].axis Immediate
ACFWFACTOR MPA.ACFWFACTOR.[set].axis Immediate
ACFGAIN PP217 MPA.ACFGAIN.[set].axis Immediate
MANACFGAIN PP217 MPA.MANACFGAIN.[set].axis Immediate
LACC1 MPA.LACC1.[set].axis Beginning of next block
LACC2 MPA.LACC2.[set].axis Beginning of next block
LFEED MPA.LFEED.[set].axis Beginning of next block
ACCEL PP42 MPA.ACCEL.[set].axis Beginning of next block
DECEL PP42 MPA.DECEL.[set].axis Beginning of next block
ACCJERK MPA.ACCJERK.[set].axis Beginning of next block
DECJERK MPA.DECJERK.[set].axis Beginning of next block
ESTDELAY MPA.ESTDELAY.[set].axis Immediate
SERVOOFF MPA.SERVOOFF.[set].axis Immediate
MINANOUT MPA.MINAOUT[.set].axis Immediate
BAKANOUT PP2 MPA.BAKANOUT.[set].axis Immediate
BAKTIME PP3 MPA.BAKTIME.[set].axis Immediate