Fagor America CNC8070 - Manual (Page 43)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
GENERAL CONCEPTS
Descr
ip
ti
on of
t
he key
s
1.
(S OFT V03.0 X )
9
Spindle control
It is used to govern the spindle. It consists of the following keys.
Execution keys
External devices
The functions of these keys are defined by the machine manufacturer and they allow
controlling the various devices of the machine (coolant, chip remover, etc.).
Start the spindle clockwise.
To stop the spindle.
Start the spindle counterclockwise.
To vary the spindle speed percentually.
Spindle orientation.
Cycle start key.
It executes the program selected in the execution mode regardless of the active
work mode (except for MDI mode). If the program has been interrupted, it resumes
its execution.
If MDI mode is active, it executes the block just edited.
Cycle stop key.
It interrupts the execution of the program or the MDI block.
RESET key.
It initializes the system setting the initial conditions as defined by machine
parameters.
Single-block execution mode.
It selects the single block execution mode. When this mode is active, the execution
of the program is interrupted at the end of each block.
Home search.
It is used to reference (home) one or several axes at the same time using a
subroutine.