Fagor America CNC8070 - Manual (Page 219)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
TOOL
AND MAGA
Z
INE TABLE
To
ol
t
abl
e
9.
(S OFT V03.0 X )
185
Machining direction.
It is defined with an icon.
It indicates the tool's machining direction.
"L" - Tool length
This data is only shown on tools that are not for turning.
"R" - Tool radius
This data is only shown on tools that are not for turning.
"LW" - Length wear
Tool length wear offset. This data is only shown on tools that are not for turning.
The CNC will add this value to the nominal length to calculate the real tool length
("Length" + "L wear").
"RW" - Radius wear
Tool radius wear offset. This data is only shown on tools that are not for turning.
The CNC will add this value to the nominal radius to calculate the actual (real) tool
radius ("Radius" + "R wear").
"A" - Cutter angle
This data is only shown for turning tools.
"C" - Cutting angle
This data is only shown for turning tools.
Icon Machining direction.
Undefined direction.
Right-hand machining direction.
Left-hand machining direction.
A tool with a radius of 20mm and a length of 134mm has a radius wear of 0.2mm
and a length wear of 0.15mm, the tool table should be set as follows:
Radius = 20 mm. Wear R = -0.2 mm.
Length = 134 mm. Wear L = -0.15 mm.
The CNC assumes as real dimensions the following.
Real radius => 20 + (-0.2) = 19.8mm.
Real length => 134 + (-0.15) = 133.85 mm.
L Tool length.
R Tool radius.
Lc Cutting length.