Cnc 8070 – Fagor America CNC8070 User Manual
Page 328
Operating manual
CNC 8070
13.
SETUP ASSI
STANCE
The
ci
rc
ul
ar
it
y (
roundne
ss)
t
e
st
(S
OFT
V03.0
X
)
294
Password-protected parameters
If the machine parameters are protected, a password will be requested when trying
to modify them. If entered correctly, it stores it and it does not request it again unless
the CNC is turned off. If the password is wrong, the values cannot be modified and
it requests it again every time.
The test may be executed even when not knowing the access password, but the
machine parameters cannot be changed.
The access passwords are determined from the utilities mode.
Initialize the value of the parameters
When turning the CNC on, it assumes the new values set by the manufacturer in the
CNC tables and/or in the drive tables accordingly. The values used the last time will
be kept for when accessing the test again later.
Pressing the
INITIALIZE
softkey sets the values assigned to the parameters as
"default values" in the tables, not those set by the manufacturer.
Bear in mind that the I N I T I AL I Z E softkey initializes al the data of the window.
i