Fagor America CNC8070 - Manual (Page 47)

13
CNC 8070
(S OFT V03.0 X )
2
HOW TO OPERATE THE CNC
2.1 Screen description
The CNC screens shows the following information:
A. General CNC-status bar.
It shows the information on the program being executed, the active operating
mode and the PLC messages. See
"Detailed description of the CNC status
bar" on page 14.
B. Screen for the active work mode.
The information shown in this area depends on the active work mode (automatic,
jog, etc.). The information shown in each work mode is described in the relevant
chapter.
C. Vertical softkey menu (icons).
The menu options change depending on the active work mode. The different
options are selected using softkeys F8 through F12.
This menu may be placed either on the left or on the right of the screen.
D. Horizontal softkey menu.
The menu options change depending on the active work mode. The different
options are selected using softkeys F1 through F7.
A
B C
D