Fagor America CNC8070 - Manual (Page 225)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
TOOL
AND MAGA
Z
INE TABLE
Act
ive-
too
ls
t
abl
e
9.
(S OFT V03.0 X )
191
9.4.1 Changing the tool of the spindle
It is possible to change the tool of the spindles from the active tools panel. The tool
to be placed must be defined in the tool table.
To change the active tool, follow these steps.
1. Use the cursor to select the active tool to be modified and enter the number of
the new tool.
2. Press the [CYCLE START] key to load the tool automatically or the [ENTER] key
to update the positions list after a manual tool change.
3. The tool list will show that the tool is in the spindle.