Cnc 8070, Softkey menu – Fagor America CNC8070 User Manual
Page 322
Operating manual
CNC 8070
13.
SETUP ASSI
STANCE
The
ci
rc
ul
ar
it
y (
roundne
ss)
t
e
st
(S
OFT
V03.0
X
)
288
Softkey menu
Horizontal softkey menu
The horizontal softkey menu offers the following options.
Softkey
SIMPLE
.
It captures the data of a full circle.
Softkey
CONTINUOUS
.
It captures data continuously.
Softkey
STOP
It stops the data capture. This softkey is shown when data capture is running.
Softkey
CLEAR
It deletes the graphic representation. It may be done while the capture is running;
in that case, it goes on with the graphic representation.
Softkey
LOAD
.
It loads a previously saved configuration.
Softkey
SAVE
.
It saves the configuration defined.
Vertical softkey menu
The vertical softkey menu offers the following options.
This softkey only stops the data capture. It does not stop the movement of the
axes. To stop the movement of the axes, press the [STOP] key of the operator
panel.
i
Softkey
VALIDATE
.
It saves the values of the machine parameters in the tables of the CNC and/or
the drive accordingly.
When changing the values of the machine parameters, the changes are effective
immediately. However, these changes are maintained only during the current
session of the CNC; i.e. until the unit is turned off. On power-up, it assumes the
values stored in the tables.
Softkey
INITIALIZE
.
It resets the window data to its default values.