Fagor America CNC8070 - Manual (Page 110)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
4.
MANUAL (
J
OG)
MODE
De
fi
ni
ti
on of
c
u
tt
ing condi
ti
on
s
(S OFT V03.0 X )
76
4.5 Definition of cutting conditions
In jog mode, it is possible to set the turning speed "S" and the feedrate "F".
• The feedrate will correspond to the active feedrate.
• The speed entered will correspond to the master spindle of the active channel.
Proceed as follows.
1. Press the [S] key on the alphanumeric keypad to select a spindle speed or the
[F] key to select a feedrate. The CNC will highlight the relevant data indicating that
it is selected.
2. Enter the desired spindle speed or feedrate.
3. Press [START] to assume the entered value or [ESC] to cancel the operation.