Fagor America CNC8070 - Manual (Page 51)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
HOW
TO
OPERATE THE
CNC
O
per
at
in
g m
ode
s
2.
(S OFT V03.0 X )
17
Task window
All CNC operating modes may be accessed from the task window. Use the [CTRL]
+ [A] keys to open the task window. Press [ESC] to close the window without making
a selection.
The task window looks like this.
A. Available operating modes
B. Shows or hides virtual jog panel.
Same as using the [CTRL]+[J] key combination.
C. Expands the list of active CNC messages.
Same as using the [CTRL]+[O] key combination.
D. Expands the list of active PLC messages.
Same as using the [CTRL]+[M] key combination.
Moving around in the task window
Besides the mouse, the following keys may be used.
After selecting an operating mode or one of the lower buttons, press [ENTER] to
activate it.
To move the cursor thru the elements of the window.
Moves the cursor over the list of operating modes.
A
C B D