Fagor America CNC8070 - Manual (Page 171)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
EDI
T
IN
G-
SI
MULATI
ON MODE
Pr
of
ile
edi
to
r
6.
(S OFT V03.0 X )
137
6.9.2 Data editing
All data need not be defined; but it is recommended to define all the known data. To
define the profile data, proceed as follows:
1. Press the softkey corresponding to the data to be defined.
2. Key in the desired value (which may be a numeric constant or an expression). Use
the [SPACE] key to change the value of a non-numerical data (tangency, direction,
etc.).
3. Press [ENTER] to accept the defined value or [ESC] to reject it and return to the
previous one. If the entered value is accepted, the CNC will select the next data.
Once all the data has been defined, press the "Validate" softkey and the CNC will
show the profile that has been defined.
Displaying incomplete sections
If there isn't enough data to show the defined section, the CNC will draw as much
of it as it knows. The sections that are not fully defined will be shown with a dash line.
If there are more than one possibility, it will show the available options one by one
except the ones that could generate tangency errors later on; select the desired
option. The sections with several possibilities will be shown in green whereas the rest
of the sections will be shown in white.
X1 = ?
Y1 = ?
X2 = ?
Y2 = ?
Angle = 60º
Tangent = Yes
X1 = 40 Y1 = 30
X2 = ? Y2 = ?
Xc = ? Yc = ?
Radius = 20
Tangent = Yes
To select the available options.
To assume the selected option.