7 protection passwords, Protection passwords, Cnc 8070 – Fagor America CNC8070 User Manual
Page 247
Operating manual
CNC 8070
UTI
L
IT
IES MODE
U
ti
lit
ie
s (
S
of
tk
eys)
10.
(S
OFT
V03.0
X
)
213
10.2.7 Protection passwords
The passwords may be used to define each of the codes that the user will have to
enter in order to access certain CNC functions. If entered correctly, it stores it and
it does not request it again unless the CNC is turned off. If the password is wrong,
the requested action cannot be carried out and it requests it again every time.
Press the "Passwords" softkey to access the password setting screen. The following
passwords may be defined.
• General password.
• PLC.
• Machine parameters.
• Customizing.
• Machine parameters for kinetics.
General password
It is requested when trying to access this password setting screen.
PLC
It is requested when trying to carry out the following actions at the PLC:
• Editing the PLC program. When entering the wrong password, the PLC program
opens as read-only.
• Adding a file to the project.
• Deleting a file.
• Renaming a file.
• Editing PLC messages. When entering the wrong password, the PLC messages
may be neither displayed nor edited.
• Generate PLC.
• When accessing to the "Commands" service options.
• In monitoring, when modifying the status of a resource.
Machine parameters
It is requested when trying to carry out the following actions in the machine parameter
table:
• Modifying the value of a parameter.
• Initialize a table.
• Loading a table.
Customizing
It is requested when entering the FGUIM application. When entering the wrong
password, it will not be possible to access the application.