Cnc 8070 – Fagor America CNC8070 User Manual
Page 142
Operating manual
CNC 8070
6.
EDI
T
IN
G-
SI
MULATI
ON MODE
Ed
it
ing wi
ndo
w (
s
of
tk
eys)
(S
OFT
V03.0
X
)
108
Customizing "Autonumbering ON / Autonumbering OFF"
It is used to turn on/off the autonumbering of the blocks. While autonumbering is
active, the CNC will insert the block number automatically every time a new block is
generated.
Customizing "Autonumbering parameters"
It is used for selecting the starting block number and the sequencing step for the
following blocks when autonumbering the blocks.
When selecting this option, the CNC shows a dialog box requesting both data. After
defining these values, press [ENTER] to accept them or [ESC] to ignore them.
Customizing "TEACH-IN parameters"
It may be used to set the behavior of each axis in TEACH-IN mode. The behavior of
an axis is defined by the properties "visible" and "selected".
Depending on these properties, one of the following behaviors may be assigned to
the axes:
• Selected and visible:
The axis is displayed in the TEACH-IN window and it is included in the blocks being
edited by pressing the [RECALL] key.
• Not selected and visible:
The axis is displayed in the TEACH-IN window, but it is not included in the blocks
being edited by pressing the [RECALL] key.
• Not selected and not visible:
The axis is neither displayed in the TEACH-IN window nor included in the blocks
being edited by pressing the [RECALL] key.
After defining the behavior of the axes, press [ENTER] to accept the selection or
[ESC] to reject it.
Show / Hide cycles and profiles
It is used for selecting whether the contents of the conversational canned cycles and
profiles will be shown or hidden in the program.
• If the "Show" option is active, it will show the full contents of the canned cycle and
the profile.
• If the "Hide" option is active, only the name of the canned cycle and the profile
will be shown.
"Visible"
The axis is displayed in the TEACH-IN window.
"Selected"
The axis is included in the blocks that are edited by
pressing the [RECALL] key.