Mdi mode, Chapter 7 – Fagor America CNC8070 User Manual
Page 185
Advertising
151
CNC 8070
(S
OFT
V03.0
X
)
7
MDI MODE
MDI mode selection
This work mode may be accessed from any channel. The blocks are executed in the
active channel.
The MDI mode lays over all the other work modes in such a way that when quitting
the MDI mode by pressing [ESC], the CNC goes into the work mode from where the
MDI mode was accessed.
Operations in MDI mode
The following operations are possible in this work mode:
• Edit and execute individual blocks.
• Save the set of blocks executed as an independent program.
The MDI mode may be accessed from any other operating mode, except when a
program is in execution (even it is interrupted) by pressing its relevant key.
Advertising