Fagor America CNC8070 - Manual (Page 344)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
14.
DDSSETUP
–I
nf
o
rm
a
ti
o
n– ser
v
ic
e
(S OFT V03.0 X )
310
Type of inputs and outputs
The inputs and outputs may be grouped as follows.
• Inputs and outputs that cannot be assigned.
These inputs and outputs indicate the status of the drive's control signals.
• Inputs and outputs that may be assigned.
Variables and/or parameters of the drive may be associated with inputs and
outputs (analog and digital).
Those digital outputs that have not been associated with any parameter or
variable may be forced to become active or inactive using the button on the left
of their led.
Speed enable Drive enable Error Reset
LSC Status DR. OK PROG. OK
Master Speed Enable Master Drive Enable Master Halt
Torque Status