Fagor America CNC8070 - Manual (Page 158)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
6.
EDI
T
IN
G-
SI
MULATI
ON MODE
G
ra
phi
c wi
ndo
w (
s
of
tk
eys)
(S OFT V03.0 X )
124
6.5.8 Options
It is used to set the appearance and some functions of the graphic window. These
options may be used at any time, even while simulating a program.
Option "Activate" / "Deactivate"
It is used to activate or deactivate the graphic representation.
When the graphic representation is deactivated and activated, the current graphic is
erased; but the display conditions are kept active (type of graphics, zoom, graphic
parameters and display area) that were active before that mode was deactivated.
Option "Simple" / "Combined"
It is used to hide or show the dialog and data areas on the right-hand side of the
graphic window so the drawing occupies the whole graphic window.
Option "Hide Tool" / "Show Tool"
It is used to hide or show the tool while simulating in "3D solid" graphics.
Option "Print"
It is used to print the graphics in a printer connected to the CNC or as a file (BMP
format) at the CNC. When printing to a file, it is saved in the folder:
"C:\Cnc8070\Users\Reports\*.bmp"
When selecting this option, the CNC will show a dialog box requesting the print
destination (printer or file).
After selecting the destination, press [ENTER] to print it or [ESC] to cancel it.
When selecting this option, the softkey menu shows the available options. To
return to the main menu, press the key for the previous menu.
Print destination
To select the print destination.
To print the drawing.
To cancel the printing.