7 –monitoring– service, Monitoring– service, Cnc 8070 – Fagor America CNC8070 User Manual
Page 342
Operating manual
CNC 8070
14.
DDSSETUP
–
M
o
n
it
o
rin
g
–
s
e
rv
ic
e
(S
OFT
V03.0
X
)
308
14.7
–Monitoring– service
The command bar is located at the bottom of the window. See
List of variables or parameters
The
ADD
softkey shows a window where one can select the variables or parameters
to be monitored and they will be shown on the screen. Variables and parameters of
any drive may be selected.
Use the
I NI TI A LI ZE
softkey to clear the whole list. To delete a variable or
parameter from the list, select it and press the [DEL] key.
The
SAVE
softkey saves the list into a file and the
LOAD
softkey restores the list from
a file.
Monitoring the status of variables or parameters
Press the
START
softkey of the horizontal menu to start monitoring. Press the
STOP
softkey to stop monitoring.
This service monitors the value of the parameters and variables of the drive. The user
selects the variables and parameters to be monitored.