Fagor America CNC8070 - Manual (Page 136)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
6.
EDI
T
IN
G-
SI
MULATI
ON MODE
Ed
it
ing wi
ndo
w (
s
of
tk
eys)
(S OFT V03.0 X )
102
6.3 Editing window (softkeys)
6.3.1 Open program
To select a program for the editing - simulation mode. This program may be a new
one or an existing one. A different program may be edited and executed in each
channel.
When selecting this option, the CNC shows a list of the available programs. See
"2.5 File selection window" on page 22.
To select a program from the list:
1. Select the folder that contains the program. If it is a new program, it will be saved
in this folder.
2. Select the program from the list or write its name in the bottom window. To edit
a new program, write the name of the program in the bottom window.
3. Press [ENTER] to accept the selection and open the program or [ESC] to cancel
it and close the program listing.