5 find/replace, Find/replace, 8070 cnc – Fagor America CNC8070 User Manual
Page 261
Operation manual
8070 CNC
PLC
Pr
ogr
a
m
edi
ti
ng
(
s
of
tk
eys)
11.
(S
OFT
V03.0
X
)
227
11.4.5 Find/Replace
It is used for searching for a line or a text in a program. It can also replace a text with
another text.
When selecting this option, the CNC shows a dialog box requesting the line number
or the text to look for. When defining a text search, certain options may also be defining
that allow:
A. Replacing the text being searched with another in the program.
B. Ignore uppercase and lowercase.
C. Consider the text to find as a whole word.
D. Select whether the search starts at the beginning of the program or at the cursor
position.
After defining the search options, press [ENTER] to start the search or [ESC] to cancel
it.
The text found in the program will be highlighted and the softkey menu will show the
following options:
• Replace, to replace the highlighted text.
• Replace all, to replace the text throughout the whole program.
• Find next, to skip this text and keep on searching.
To end the search, press [ESC].
Find/replace
To move the cursor through the elements of the list.
To activate/deactivate the selection box (B) (C).
To select an option of a group (D).
To start the search.
To cancel the search and close the dialog box.
A
B
C
D