9 command generator, Command generator, Cnc 8070 – Fagor America CNC8070 User Manual
Page 345
Operating manual
CNC 8070
DDSSETUP
Com
m
and
ge
ner
a
tor
14.
(S
OFT
V03.0
X
)
311
14.9
Command generator
The fields to be configured at the generator are:
Shape
To select the type of signal to be generated with the drive
(sinusoidal or square).
Amplitude
Signal amplitude.
Frequency
Signal frequency.
Offset
Signal Offset.
Waves
Number of waves to generate. When set to 0 (zero), the
waves are generated continuously, without interruption.
Duty Cycle
Percentage of the wave at 1/0 (only on squarewaves).
The internal command generator is turned on and off using the lower buttons.
This option may be used to configure and start up the internal command generator
of the drive. In the configuration, it is possible to establish the shape of the signal,
its amplitude, period, etc.
It turns the command generator on.
It turns the command generator off.
Selected drive
Turn the command generator
on.
Configuration of the command
generator.