Fagor America CNC8070 - Manual (Page 329)

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ Operating manual
CNC 8070
SETUP ASSI
STANCE
The
ci
rc
ul
ar
it
y (
roundne
ss)
t
e
st
13.
(S OFT V03.0 X )
295
13.3.7 Validate the changes and save the configuration used
Validate the parameters
The new data is assumed by the CNC until the unit is turned off. Once the setup is
completed, the changes must be saved so they can be effective next time the CNC
is turned on.
When quitting the circularity test without having saved the parameters, the CNC will
show a message warning about it and will give a chance to save them.
Save and load the configuration
The system permits saving the current configuration into a file in ASCII format
(extension "TST"). This file only contains the configuration. It contains neither the
graphics nor the values of the machine parameters. When loading a configuration,
the parameters assume the value they have at the time.
Save the configuration
Press the SAVE softkey to save the current configuration. Select the folder and the
file name and press [ENTER]. If there is a configuration already saved with the same
name, it will ask whether it is to be replaced or not.
By default, the configuration is saved in the folder "C:\CNC8070 \MTB \DATA" or in
the last folder selected by the user.
Load the configuration
Press the LOAD softkey to load a previously saved configuration. Select the folder
and the file name and press [ENTER].
Use the VALIDATE softkey to save the data. The CNC saves the new values in the
CNC tables and/or in the drive tables accordingly.
The configuration saving option does not update the machine parameter
table. To do that, use the
VAL IDATE softkey.
i